Eds truck

Pretty much an open forum. Need to get something off your chest? Dump it here.
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

Yes, sounds better in person too.
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

My aftermarket plastic speedometer cable drooped down onto the exhaust and melted, Doh! I replaced it a couple days ago, and tied it up good.
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

Finally got the lights on, made a bracket that bolts to the back of the winch.

Image

Image
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

Got the rock sliders and skid plate back from the powder coater.
Image

Image
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

Made three new posts for the drivers side of my truck too.
Image

Image
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
User avatar
Wickedtuna
Three-quarter tank
Three-quarter tank
Posts: 95
Joined: Mon Jan 30, 2017 3:04 pm
Location: San Diego
Vehicle(s): 1975 International Scout II, 2002 Jeep Grand Overland, 2000 Toyota 4 Runner Limited

I actually liked that they were crooked, lol
William Sousa
San Diego Chapter
1975 Scout II XLC
304, 727 A/T
SOA Full Width Chevy Axles
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

A lot more people said that than "fix that"...... Even strangers that aren't into 4WD or International.
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

The only gear I could get into in the rear transmission was 3rd, had to drive home from wheeling in overdrive in the front box, and 3rd in the rear box. Turns out a set screw fell out of one of the shift forks, two other set screws were pretty loose. There was also a pin from one of the shift rails in the bottom. Got the top cover all back together today, will start on installing it tomorrow.
Image Image Image
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

The hood kept getting stuck, turns out the tacks were broken loose on the nut on the back side. Here it's ready to weld, I don't have welded pictures yet.
Image Image
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

Oops! Image Image Image Image
Could someone go look at this for me? Paying attention to drivers side door and fender, the rest will be bonus parts......
https://orangecounty.craigslist.org/cto ... 96550.html
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
Post Reply