Eds truck

Pretty much an open forum. Need to get something off your chest? Dump it here.
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

Ha!
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

Noticed this a few days ago, already taken care of.
Attachments
A56E7620-4F27-48EE-9A4A-1F142CB186D1.jpeg
A56E7620-4F27-48EE-9A4A-1F142CB186D1.jpeg (449.84 KiB) Viewed 2301 times
7403E14B-A762-49F2-B441-3CAF7BC297A2.jpeg
7403E14B-A762-49F2-B441-3CAF7BC297A2.jpeg (343.39 KiB) Viewed 2301 times
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
User avatar
Desert Scout
Full Tank
Full Tank
Posts: 124
Joined: Tue Jan 24, 2017 4:15 pm
Vehicle(s): 63 & 64 S80 4x4

OUCH!!
Chuck & Ruthie
WN7CHK & KJ6RTJ
87 HD FLHTP
2011 Ranger S/C
1990 F350 Lariat S/C Dually
1990 S&S 11SCB Camper
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

No doubt, I’ve never seen such a thing. Mike says he’s seen it a few times.
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

Used the truck to run errands today, everything seems good. The brakes work better than they have in a while, replaced a few parts that needed it.
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

I replaced the drivers side rear wheel cylinder yesterday, it was leaking. Today I adjusted the brake shoes back out, I had to back them off to get the drum off. Also bled the brakes today, it took a long time to get the fluid moving, then to get all the air out. But seems good now.
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
Post Reply