Ed’s Travelall

Pretty much an open forum. Need to get something off your chest? Dump it here.
Post Reply
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

Got this engine from big John, put in new rings, did a valve job, replaced rod bearings, oil pump, valve springs, water pump, thermostat, and spark plugs, then resealed it.
Attachments
F75201EB-A531-4DD1-859A-EB9EF241788E.jpeg
F75201EB-A531-4DD1-859A-EB9EF241788E.jpeg (2.53 MiB) Viewed 3310 times
ADC359D3-7AF9-4511-86F5-6DDC640C5537.jpeg
ADC359D3-7AF9-4511-86F5-6DDC640C5537.jpeg (1.72 MiB) Viewed 3310 times
92480A9D-1B03-4D39-8CE5-11D2DA269592.jpeg
92480A9D-1B03-4D39-8CE5-11D2DA269592.jpeg (2.58 MiB) Viewed 3310 times
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

Attachments
B3DCB9BE-8365-4C9F-953A-AD1BF2720FAB.jpeg
B3DCB9BE-8365-4C9F-953A-AD1BF2720FAB.jpeg (1.91 MiB) Viewed 3307 times
D6CC1A7C-094B-4F00-A1C5-6F49DA904552.jpeg
D6CC1A7C-094B-4F00-A1C5-6F49DA904552.jpeg (2.46 MiB) Viewed 3307 times
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
User avatar
fpscabs
No limits
No limits
Posts: 206
Joined: Mon Jan 16, 2017 9:45 pm
Location: Glendora, CA
Vehicle(s): 1970 Travelall

sweet. Looking good
Fritz...
Past President, Main Chapter
OHV 167v SBNF
KJ6RUN
Certifications:
First Aid, Chainsaw, 4x4, ATV,


1970 Travelall, 392 1100D
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

Thanks. Almost had it ready in time for Scoutsmas, ran out of time.
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

The roll up handle on the tailgate broke on the back side, I put the piece it engages with onto this T handle. It has splines to engage with the regulator. I can use this until I get another handle, or change to electric.
Attachments
image.jpeg
image.jpeg (189.09 KiB) Viewed 1648 times
image.jpeg
image.jpeg (310.69 KiB) Viewed 1648 times
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
User avatar
fendermonkey
Full Tank
Full Tank
Posts: 108
Joined: Mon Jan 16, 2017 9:57 pm
Location: Anaheim
Vehicle(s): 75 Scout II

There's always a way to make something work.
Brad Spears
KK6UYY
User avatar
Big Ed
No limits
No limits
Posts: 228
Joined: Thu Jan 19, 2017 8:01 pm
Location: Fresno, CA
Vehicle(s): C1300 and 1110D

Yep.

I got Mike checking on everything I need to convert to electric.

Havn't been able to find a manual type handle.
64 C1300 4X4, 345, T34, T18, NP202, D70F with ARB & 35 spline Chromoly axles, RA15 with Detroit Locker, 41" Iroks, front & rear PTO winches, recent makeover.
Post Reply